After
the post sections are slip-fitted
together on the ground, two men can
easily set up the Model 520 A Lift in
upright position. The outriggers and the
guy cables are adjusted and tensioned to
maintain a vertical mast under load.
Model
520-A3
Complete (with 3" casters)
Model
520-A5 Complete
(with 5" casters)
OUTRIGGER
BASE
Both outriggers
are equipped with
two U-clamps. Each U-clamp is
secured to the base with a single
screw and wing nut.
OSHA
ACCEPTED
One man can now lift 500 lb.
loads up to 20 ft. in two minutes or less - this can be done with the
Model 520A Lift.
Thisunit is equipped with guy cables, outrigger bars, and adjustable wing-screw
levers with sturdy rubber feet to
stabilize the load. If used on bare ground, wood buckets should be placed
under casters and levers. To move the
unit on hard surface, simply raise the rubber footed levers slightly to
allow the swivel casters to turn freely.
Where intermediate heights
are desired, the model is quickly converted to a 16, 14, 10 or even a
5 ft. lift, either
by removing or replacing the proper post sections. 2 ft. post section
shown in specifications page provide for all
intermediate heights in 2 ft. increments. When the MODEL 520A is assembled
as a 5 ft. lift, it can be tipped back
on the corrugated handle and rolled into a truck or Van.
WARNING: DO NOT USE EXTRA POSTS TO INCREASE THE DESIGNED MAXIMUM HEIGHT OF
20' ON THE MODEL 520A LIFT.
The
520A Lift becomes and excel-
lent elevator when attached to safe
way scaffolding. Corner brackets
shown below provide solid support.
520A Multi-Purpose Lifts,
Elevating Work Platform, Superlift, Installation Lifts, Maintenance Lifts,
Material Lifts, Portable Lifts,
Super Hoist, and Vermette Lifts from your source for material handling
equipment.