Toggle Nav
My Cart
Quote
Menu
Account

TYPE 63 - Angle Base Flange
Type 63 Angle Base Flange is used to set up the upright at an angle between 45 and 60 degrees.

This fitting is similar to Type 62, but is used to set up the upright at an angle
between 45° and 60°. This fitting should only be subjected to light loads due to its
size and the base fixing holes, which cannot be positioned at 90° to the applied
load for normal staircase and ramp guardrail applications. For greater loads or
other pipe sizes, Type 62 flange is used and the upright bent to the required angle.
PIPE SIZE NOTE: Pipe sizes are specified by the inside diameter. Refer
to diagrams below the price chart to verify your outside diameter.

Order Online

Click the button of the item you wish to purchase.

Contact us for special lengths

Type 63 Base Angle Flange should only be subject to light loads due to its size and base fixing holes, which cannot be positioned at 90 degrees to the applied load for normal staircase and ramp guardrail applications.
Model No.
Pipe Size
Inches
Lbs
Price
A
D
E
F
G
H
Ø
Angle Base Flange
1 1/4"
2.99
5.43
3.74
4.17
0.39
0.55
2.54
$56.64
1 1/2"
3.54
6.1
3.94
5.43
0.39
0.55
3.31
$72.10
Note: Ø indicates diameter of fixing holes.
Pipe sizes are specified by the inside diameter; refer to this diagram to verify the outside diameter.
Many other colors available. Prices are upon request.
Kee Klamp fittings are available in many different colors; prices are upon request.
Kee Clamp, Kee Clamps, Kee Klamp, Kee Klamps, Key Clamp, Pipe Hand Rail, Pipe Handrail, Pipe Rail, Pipe Rail Fittings, Pipe
Railing, Pipe Rails, and Slip on Pipe Fittings from your complete source for material handling equipment.